Why Radon Tests Are Supposed to Happen in Winter: the Closed-House Effect Nobody Explains

Radon test kits say 'closed-house conditions' on the box and leave it there. Here is the stack-effect mechanism that makes winter the season an EPA-protocol test actually means what it says.

Byron bought a radon test kit in March after a neighbor mentioned it at a barbecue, meant to run it that weekend, and instead left it sealed in the box on a closet shelf through spring and most of summer. By September he'd half-forgotten why he bought it. The instructions on the box say to keep the house in "closed-house conditions" for the test. What they don't say is why a test run in September, or June, or any random weekend, isn't the same test as one run in January.

The short answer: the number on a radon test only means what the EPA action level assumes it means if the house was doing what houses do most consistently in winter.

The Test Has Rules for a Reason

The Environmental Protection Agency's (EPA) short-term radon test protocol specifies closed-house conditions: exterior doors and windows shut except for normal entry and exit, and the heating, ventilation, and air conditioning (HVAC) system running as it normally would, for a minimum 48-hour test. That isn't paperwork for its own sake. It standardizes the test so a reading from one house means the same thing as a reading from another, and so both can be compared honestly against the EPA action level of 4.0 picocuries per liter (pCi/L). A test run with windows cracked open dilutes the air the kit is sampling, and the number that comes back can read lower than what the household actually breathes during the months the house is sealed and running heat.

This is also why the device-focused side of radon testing, covered in what a consumer radon monitor tells you and what it misses, is a separate question from the one this piece answers. That piece is about which device to trust and when a reading needs certified confirmation. This one is about when to run the test in the first place, so the reading you get is worth trusting.

Why Warm Air Leaving the Top of the House Pulls Soil Gas In at the Bottom

Warm indoor air is less dense than cold outdoor air, so it rises. As that heated air works its way up through the house and escapes through small gaps near the attic, roofline, or chimney, it leaves behind a slight negative pressure at the lower levels of the structure. Air pressure doesn't like an imbalance, so something has to move in to equalize it, and the path of least resistance is often through foundation cracks, slab penetrations, and openings around sump pits and utility lines. That's exactly where soil gas, including radon, gets pulled in. Building scientists call this the stack effect, and it runs year-round to some degree. What changes by season is how strong it is, and that scales directly with the temperature gap between inside and outside, and with how consistently the heating system is running.

Cold, Sealed, and Heated, All Three at Once

Winter in the Inland Empire (IE) lines up all three conditions that push the stack effect to its strongest point: the largest sustained gap between indoor and outdoor temperature of the year, the longest stretch of days where windows and exterior doors stay shut without anyone thinking twice about it, and a heating system running continuously rather than cycling on for the occasional cold snap. A test run in summer can land on a day when windows happened to be open for half the afternoon, or during a season when the indoor-outdoor temperature gap barely exists to begin with. A winter test, run during a stretch of ordinary cold weather, catches the house doing what it does most consistently for the longest stretch of any season, which is also the condition the EPA action level assumes when a homeowner lines their result up against it.

How far a single house's reading can swing between seasons is not something to state as a universal number. At least one studied building has shown a dramatic seasonal difference, with readings reported in the rough range of 1.8 to 2.2 pCi/L in summer climbing to somewhere around 28 to 32 pCi/L in winter. That is a documented figure in a specific case, not a multiplier that applies to a typical IE home, and it should be read that way: as evidence that the swing can be real and sometimes large, not as a formula for predicting your own house's number. Most homes will not swing anywhere near that far. The point worth taking from it isn't the exact figures, it's that a summer-only test, run with windows occasionally open, can genuinely understate the radon exposure a household experiences during the six or seven months the house runs sealed and heated.

When to Actually Run the Kit in the Closet

The practical version of all of this: pick a stretch of consistently cool weather, ideally with the heating system running on a regular basis rather than an unseasonably warm week where it barely kicks on. Get the house into genuine closed-house condition, windows and exterior doors shut except for normal entry and exit, for at least 12 hours before starting the test, and hold that condition for the full 48-hour duration. A test technically run "in winter" during an odd warm spell with windows cracked for fresh air doesn't capture the conditions the protocol is built around, even if the calendar agrees it's January.

For homes anywhere in San Bernardino or Riverside County, county-level radon zone designations exist as a screening reference, but they don't replace testing a specific house. Both counties sit in EPA Radon Zone 2 (moderate potential, predicted average indoor screening level between 2 and 4 pCi/L), per EPA's Map of Radon Zones. That screening gap is one more reason the test itself, run at the right time of year, is what actually tells you where your house stands.

Closed-House Doesn't Mean Sealed-Up-Forever

Because the IE has no basements in typical residential construction, the stack effect here works through the foundation slab, garage-to-house shared walls, and gaps around utility penetrations rather than a below-grade basement wall. A single-story slab-on-grade home still develops the same negative pressure at its lowest level that a two-story home does. It just does it at the slab instead of a basement floor. Closed-house conditions apply the same way regardless: normal entry and exit only, HVAC running as usual, no propping a door open to air the place out mid-test.

The Takeaway

The winter-testing rule isn't a calendar suggestion. It's a physics requirement. The stack effect that pulls soil gas into a house is strongest exactly when the house is coldest, most sealed, and most consistently heated, and that's winter, specifically a stretch of winter without an unseasonable warm spell in the middle of it. Run the test then, hold genuine closed-house conditions for the full window, and the number that comes back actually means what the EPA action level assumes it means.

Prevention Checklist

  • Buy the test kit before winter arrives, not during a warm spell
  • Choose a stretch of consistently cool weather with the heating system running regularly
  • Confirm closed-house conditions (windows and exterior doors shut, HVAC operating normally) for at least 12 hours before starting the test
  • Maintain closed-house conditions for the full 48-hour test duration
  • If the result is at or above 4.0 pCi/L, follow up with a second short-term or long-term test before assuming mitigation is needed

When to Call a Pro

If a winter short-term test returns 4.0 pCi/L or higher, EPA guidance calls for a second short-term test to confirm it, or a longer-term test, before deciding on mitigation. If that confirmation also comes back elevated, the next step is a certified radon-mitigation professional. Call 909-270-2203 with questions about indoor air quality testing across the Inland Empire.

Frequently Asked Questions

Does radon testing timing actually matter, or is any 48-hour period fine?

Timing matters because the closed-house protocol is trying to catch the conditions your house runs in for months at a time, not a random two days. A 48-hour window in the middle of summer with windows opening and closing off and on will not produce the same number as the same 48 hours in a stretch of consistently cool, sealed, heated winter weather.

What is the stack effect and does it apply to single-story IE homes?

The stack effect is warm indoor air rising and escaping through gaps near the roofline, which pulls outside air, including soil gas, in through the foundation to replace it. It applies to single-story homes too. The effect scales with the indoor-outdoor temperature difference and how sealed the house is, not primarily with how many stories it has.

Can I test for radon in summer if that's when I remember to do it?

You can run a test any time of year and it will tell you something. It just will not tell you the number the EPA action level assumes, which is built around closed-house winter conditions. A summer result is better than no result, but treat it as a rough floor, not the number to compare against 4.0 pCi/L with full confidence.

What radon level requires mitigation?

The EPA action level is 4.0 picocuries per liter (pCi/L). A result at or above that level calls for a confirming follow-up test, not an immediate mitigation contract. If the follow-up test also comes back at or above 4.0 pCi/L, EPA guidance calls that the point to bring in a certified mitigation professional.

Does the closed-house rule mean I can't run the AC or heater during the test?

No. Closed-house conditions mean windows and exterior doors stay shut except for normal entry and exit. Your heating system is supposed to run normally during the test. Running the heater is part of what makes a winter test representative, not something to avoid.