Water at the Patio Slider After Winter Rain: What the Track Is Meant to Do and What Clogs It
A sliding patio door track is built to drain water back outside through weep holes. What clogs them, where the overflow goes at the threshold, and the simple checks that come first.
Corwin heard the rain before he saw it, a December front pushing sideways across the patio hard enough to rattle the lemon tree against the fence. By mid-afternoon there was a thin sheet of water standing in the lower track of the sliding door, and the tile just inside the glass felt cooler under his sock than the rest of the room. He stood there deciding between a towel and a phone call.
Corwin is an illustrative composite, not a documented ADR client. Your own door, weather and flooring will differ.
The short answer: that track has a drain built into it, and most threshold leaks start when the drain stops working. A short check on a dry day tells you which kind of problem you have.
The Track Is a Small Gutter
A sliding patio door does not seal water out the way a solid wall does. The sill and track are shaped to catch what gets past the glass and the panel, hold it briefly, and let it leave through small slots in the exterior side of the frame. Those slots are called weep holes. Andersen's care guidance says water pooling in the sill is usually temporary, and that if it does not drain, dirt, debris or sealant may be blocking the weep holes.
Winter in the Inland Empire (IE) adds wind to the picture. Winter storms can push rain sideways, and sideways rain reaches places a vertical rain never would, including the face of a patio door and the bottom of its track. The door industry treats this as a real, testable condition. The American Architectural Manufacturers Association (AAMA), now part of the Fenestration and Glazing Industry Alliance, publishes test method AAMA 501.1, which applies water to a window or door while air pressure is pushed against it to imitate wind-driven rain. ASTM International method E1105 does the same job in the field on products already installed. A door can pass in a lab and still meet a day when the drain is full of leaves.
For the bigger picture of how storm water finds its way into IE homes, see how atmospheric river water intrusion works.
What Clogs the Drain
Weep holes are small, low to the ground, and out of sight, which is the combination that makes them easy to forget. Andersen lists dirt, debris and sealant as the usual blockers. Green Building Advisor's editor, Martin Holladay, writes that weep holes are often clogged by dirt or plant matter. On a patio in the IE that means fine dust that dries into a crust, leaf litter, citrus drop, spider webbing, and the occasional bead of caulk or paint from a past touch-up.
Andersen adds that homes in coastal, industrial or agricultural areas should clean more often. Dust from a nearby construction lot or an agricultural field packs into the slots the same way. If your patio is dusty, assume your weep holes collect it.
Where the Overflow Goes
When the slots are blocked, the track keeps filling with every gust of rain. Eventually the water has two ways out. It can climb over the inner lip of the sill and onto the floor, or it can seep past the threshold and under the trim.
In a slab-on-grade IE home, the threshold is the low point of the opening. The patio is close to the slab level, the flooring butts up to the door, and the first things water meets are the flooring edge, the carpet tack strip or the edge of a floating floor, the bottom of the baseboard, and the slab edge hidden below them. None of it is easy to see, and most of it sits under trim. A wet towel on the visible tile does not mean the hidden edge is dry. For more on how moisture moves through and under slab floors, read slab-on-grade moisture realities.
The Environmental Protection Agency (EPA) guidance on water damage gives a useful time marker. Carpet and backing should be dried within 24 to 48 hours, and the agency states that mold growth will not always occur after 48 hours and that the number is only a guideline. It also notes that mold growth may have occurred even when drying met the window. Materials wet longer than that need a different response than a towel and a fan.
Signs Worth Noticing
The glass rarely tells the story. The edge of the floor does. Look along the threshold for:
- Baseboard near the door that has swollen, softened or started to peel at the bottom
- Carpet along the door that looks darker than the rest, or a tack strip with rust or staining
- Flooring planks at the door edge that have lifted, cupped or opened at the seams
- Paint bubbling or staining on the trim and lower wall beside the frame
- A faint musty smell that is strongest near the door and fades as you walk away
One of these is a reason to look closer. Several of them together is a reason to measure. For a wider list of what to watch for around the house, see signs of water damage.
Checks You Can Do on a Dry Day
None of this needs special tools.
- Vacuum the track. Get the loose grit out first so you can see the slots. Andersen recommends cleaning the sill track regularly with a soft brush and warm, mild soapy water, then letting it dry. Milgard suggests a non-abrasive cleaner.
- Find the weep holes. They sit along the exterior bottom rail. Milgard's guide says to pop the exterior covers out with a putty knife. Some Andersen doors have no cover and put the weep holes under the stationary panel, so look up your model before you pry at anything.
- Clear each slot. A pipe cleaner or soft brush is what both manufacturers describe. Skip harsh solvents and hard tools that could scar the frame.
- Run the water test. Pour some water into the track and watch it. Milgard describes this as the way to confirm the weep holes are clear. It should leave through the weep holes to the outside, not sit.
- Leave the track dry. Andersen advises against lubricating the track itself, since the rollers are meant to roll, not slide. If you use a lubricant on the hardware, Milgard suggests silicone and not oil-based products, which hold onto grime.
- Do it before the storm. Milgard recommends checking the weep holes ahead of heavy rain in the forecast, which in the IE means before the first big front of the season.
Also look up. Holladay notes that a wide roof overhang keeps rain off the threshold except in extreme conditions such as unusually high winds. An uncovered patio facing the wind will test the door harder than a covered one.
When the Weep Holes Are Clear and Water Still Comes In
Sometimes the water test passes and the floor still gets wet. That points past the track, to the way the door was set into the wall.
A sill pan is a waterproof tray under the door, and a back dam is a raised lip on the inside edge of that tray. The U.S. Department of Energy's Building Science Education Solution Center describes the sill as especially vulnerable and recommends a back dam and self-adhesive flashing there to direct water away from the opening. The Pacific Northwest National Laboratory's Building America Solution Center calls the sill "the location most vulnerable to water intrusion" and explains that a sill pan collects water that gets past the door and sends it back out. The center adds that in high-wind areas a door set in a pan resists wind-driven rain better, and it sends readers to the door manufacturer's instructions for the sill details. Trade publication Journal of Light Construction has written that tape-only pans often lack a back dam and proper slope.
You cannot see any of this from inside the room. This is the question to take to the door contractor or the builder: how was the sill pan done under this door, and can the installation be tested? Sealant across the sill is not the answer. A pan is meant to drain outward, and caulk across it can trap water where it should be leaving.
ADR does not repair, flash or replace doors. We document the moisture, dry the area, and tell you what the readings suggest so the licensed door trade can work from facts.
When Moisture Readings Matter
A reading is worth having when any of these is true: the signs above are already present, water has crossed the track more than once this season, the floor edge feels damp or cool to the touch, or the musty smell near the door keeps coming back.
A moisture meter compares the threshold against a dry reference spot on the same material elsewhere in the room. Mapping it along the whole width of the door shows how far the water travelled, which is the part nobody can judge by looking. The method is explained in moisture mapping, when and why. If the edge is wet, drying it inside the 24 to 48 hour range EPA describes gives you the best chance of saving the flooring edge and keeping the air near the door clean. If it is dry, you have an answer and a clean track. That is the choice Corwin faced at the glass: the towel deals with the water he can see, and the reading tells you about the edge he cannot.
When to Call
If the floor edge, tack strip or baseboard by your patio door looks wrong after a storm, ADR will read the moisture, map how far it reaches and tell you plainly what it finds. Call 909-270-2203 for questions about water at a threshold anywhere in the Inland Empire.
Frequently Asked Questions
Is it normal for water to sit in the sliding door track when it rains?
A little, for a short time, yes. Andersen describes water pooling in the sill as usually temporary. The track is designed to hold some water and send it outside through weep holes. Water that stays put after the rain stops, or that crosses the track onto the floor, means the drain is blocked or something else is adding more water than the track can shed.
How do I clean sliding door weep holes?
On a dry day, vacuum the track, then look along the bottom of the exterior frame for the small slots. Lift the cover if your door has one, clear each slot with a pipe cleaner or a soft brush, and pour a cup of water into the track to confirm it runs out. Both Milgard and Andersen publish this method. Some Andersen doors have no cover and carry the weep holes under the fixed panel, so check your manufacturer's care page for your model.
What is a sill pan and can I check mine?
A sill pan is flashing under the door threshold that catches any water getting past the door and directs it back outside. The Department of Energy and the Pacific Northwest National Laboratory both describe it as protection for the most vulnerable spot in the opening. It is built into the wall during installation, so a homeowner cannot see or test it. If water keeps entering with clear weep holes, ask the door contractor or builder about it.
How long can flooring stay wet near a patio door before mold becomes a concern?
The Environmental Protection Agency (EPA) guidance says carpet and backing should be dried within 24 to 48 hours, and that mold growth will not always occur after 48 hours, so the figure is a guideline and not a switch. Dried materials can still have had mold growth, and materials wet longer need a different response. A moisture reading at the threshold tells you whether the edge is still wet.